2026 Index Active
IRS Sec 25C Updated
UPDATED APRIL 2026 • EPA RADON ZONES 1–3 • ANSI/AARST SGM-SF STANDARD

2026 Radon Mitigation System Cost Calculator

Estimate turnkey installation costs for Active Sub-Slab Depressurization (ASD) and Crawlspace Sub-Membrane (SMD) radon systems. Powered by state-level EPA Radon Zone data (pCi/L), NRPP labor rates, and 24/7 continuous fan electricity calculations.

2026 EPA Zone & NRPP Estimator

Radon Mitigation System & Vapor Barrier Cost Calculator

EPA Action Level: 4.0 pCi/L + ANSI/AARST SGM-SF
Sub-Slab ASD • 1 Suction Point
$1,150 – $1,650
Full Breakdown ↓
1,400 sq. ft.
600 sq ft 1,500 sq ft 2,500 sq ft 3,500 sq ft
2026 NRPP Certified Turnkey Quote EPA Zone 2 • 4.1 pCi/L Avg
Estimated System Installation Range
$1,150 – $1,650
Target Post-Mitigation: < 2.0 pCi/L 24/7 Fan Power: $81/yr
State Geological Radon Profile Fan Draw: 55W Continuous

Active soil depressurization (ASD) maintains negative pressure (-0.2" to -1.8" WC on the U-tube manometer) beneath the slab to exhaust soil gas above the roofline before entry.

Radon Fan, Schedule 40 PVC & Manometer $465
Core Drilling, Suction Pit & NRPP Labor $690
Crack Sealing / Sump Dome / Membrane $160
Electrical Disconnect + Post-Mitigation CRM Test $185
Real Estate Escrow Guarantee: Most NRPP/NRSB certified mitigators include a written guarantee reducing indoor radon below 4.0 pCi/L (and typically under 2.0 pCi/L) within 48 hours of activation.

2026 Radon Mitigation Cost by Foundation & System Type

National average turnkey quotes from NRPP/NRSB certified radon mitigators, including core drilling, Schedule 40 PVC stack, inline fan, U-tube manometer, and post-mitigation continuous radon monitor (CRM) verification.

Mitigation System Type 2026 Installed Range Typical Fan Model Expected Reduction
Sub-Slab ASD (Post-2000 Gravel Base) $1,150 – $1,650 RP145 / Maverick (45–60W) 85% – 96% (<1.5 pCi/L)
Sub-Slab ASD (Pre-1985 Tight Clay / 2 Drops) $1,600 – $2,350 GP501 / Eagle Extreme (95W) 80% – 92% (<2.0 pCi/L)
Sump Pit & Drain-Tile Depressurization $1,350 – $1,950 RP145 + Sealed Lexan Dome 90% – 98% (<1.2 pCi/L)
Dirt Crawlspace SMD (12-Mil Vapor Barrier) $2,200 – $3,900 RP145 + Perforated Collector 85% – 95% (<1.8 pCi/L)
Passive New-Construction Stub Activation $650 – $980 Attic Fan Cut-In Only 85% – 95% (<1.5 pCi/L)

Frequently Asked Questions About Radon Mitigation

How much does a radon mitigation system cost in 2026?

In 2026, a standard active sub-slab depressurization (ASD) radon mitigation system costs between $1,150 and $1,650 installed for homes with a permeable gravel base. Older homes with tight clay soil requiring two suction points cost $1,600 to $2,350, while dirt crawlspace sub-membrane depressurization (SMD) systems with a 12-mil reinforced vapor barrier range from $2,200 to $3,900.

At what radon level does the EPA recommend mitigation?

The U.S. Environmental Protection Agency (EPA) sets the federal action level at 4.0 picocuries per liter (pCi/L) of air, and recommends considering mitigation for levels between 2.0 and 3.9 pCi/L. The World Health Organization (WHO) recommends a reference action level of 2.7 pCi/L (100 Bq/m³).

How much electricity does a radon fan use per year?

A standard inline radon fan (such as a RadonAway RP145 or Festa AMG Maverick) draws 45 to 65 watts continuously (~480 kWh per year), costing $65 to $95 per year at average U.S. electricity rates. High-suction fans for tight clay soil draw 85 to 125 watts, costing $120 to $190 per year.

Should the radon exhaust pipe run on the exterior wall or through the garage attic?

An exterior sidewall PVC run is $250 to $500 cheaper and avoids cutting into interior drywall or roof decking, though the PVC pipe and fan housing remain visible on the side of the home. Routing the pipe up through an attached garage and penetrating the garage roof hides the fan in the attic and improves curb appeal.

How long does a radon mitigation fan last?

Continuous-duty residential radon fans carry a 5-year manufacturer warranty and typically last 8 to 12 years running 24/7/365. Replacing a burned-out radon fan unit inside an existing PVC stack costs $320 to $490 including labor.